Delete All - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Meas Setup

Delete All

Marks and deletes all signals in the signal list. If you accessed this function from the front panel, the
following message will prompt you for confirmation to delete all signals from the signal list.
This will delete all signals. Are you sure you want to do this?
Please press Enter or OK to proceed. Press ESC or Cancel to close this dialog.
Key Path
Remote Command
Example
Notes
Dependencies
Initial S/W Revision
Delete Marked
Deletes all marked signals in the signal list. If you accessed this function from the front panel, the following
message will prompt you for confirmation to delete the selected signals from the signal list.
This will delete the marked signals. Are you sure you want to do this?
Please press Enter or OK to proceed. Press ESC or Cancel to close this dialog.
Key Path
Remote Command
Example
Notes
Dependencies
Initial S/W Revision
Delete Unmarked
Deletes all unmarked signals in the signal list. If you accessed this function from the front panel, the
following message will prompt you for confirmation to delete the selected signals from the signal list.
This will delete the unmarked signals. Are you sure you want to do this?
446
Meas Setup, Signal List, Delete Signals
:CALCulate:FSCan:SLISt:DELete:ALL
CALC:FSC:SLIS:DEL:ALL
If the signal list contains no data, an error is generated and this function cannot be performed.
When signals in the signal list were successfully deleted, an advisory is generated.
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
A.07.00
Meas Setup, Signal List, Delete Signals
:CALCulate:FSCan:SLISt:DELete:MARKed
CALC:FSC:SLIS:DEL:MARK
If the signal list contains no data, an error is generated and this function cannot be performed.
If no marked signal is found in the signal list, an error is generated and Delete Marked cannot be
performed.
When signals in the signal list were successfully deleted, an advisory is generated.
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
A.07.00
EMI Receiver Mode Reference