Keysight x-series User Reference Manual page 466

8 Frequency Scan Measurement
Meas Setup
Example
Dependencies
Preset
State Saved
Range
Initial S/W Revision
Key Path
Remote Command
Example
Dependencies
Preset
State Saved
Range
Initial S/W Revision
Remote Command
Example
466
[:SENSe]:FSCan:SCAN[1]|2|...|10:POWer:GAIN[:STATe]?
FSC:SCAN4:POW:GAIN ON Turn on Internal Preamp of Range 4.
FSC:SCAN4:POW:GAIN?
Preamp is not available on all hardware platforms. If the preamp is not present or is unlicensed, the
key is not shown.
This key is grayed out during multi range scanning. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict; Function not available while running multirange scan" warning.
This key is grayed out during final measurement. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
OFF
Saved in instrument state.
On|Off
A.07.00
Meas Setup, Scan Table
[:SENSe]:FSCan:SCAN[1]|2|...|10:POWer:GAIN:BAND LOW|FULL
[:SENSe]:FSCan:SCAN[1]|2|...|10:POWer:GAIN:BAND?
FSC:SCAN3:POW:GAIN:BAND LOW Set Range 3 to Low band Preamp.
FSC:SCAN3:POW:GAIN:BAND?
Preamp is not available on all hardware platforms. If the preamp is not present or is unlicensed, the
key is not shown.
If a POW:GAIN:BAND FULL command is sent when a low band preamp is available, the preamp band
parameter is set to LOW instead of FULL, and an "Option not installed" message is generated.
This key is grayed out during multi range scanning. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict; Function not available while running multirange scan" warning.
This key is grayed out during final measurement. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
LOW
Saved in instrument state.
Low Band|Full Range
A.07.00
[:SENSe]:SCAN[1]|2|...|10:INPut:GAIN[:STATe] ON|OFF|1|0
[:SENSe]:SCAN[1]|2|...|10:INPut:GAIN[:STATe]?
SCAN5:INP:GAIN ON Turn on low band preamp in Range 5.
EMI Receiver Mode Reference