Select Signal - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Meas Setup

Select Signal

Specifies the selected signal. The term "Selected signal" is used throughout this document to specify
which signal will be affected by the functions.
Key Path
Notes
Dependencies
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision
Mark Signal
Marks the checkbox next to the selected signal.
Key Path
Remote Command
Example
Notes
Dependencies
Initial S/W Revision
Mark Duplicates
This menu enables you to mark the signals that are duplicates. A signal is considered to be a duplicate if it
is within the width of the 3 dB RBW value. Signals cannot be duplicate unless they are measured using the
same 3 dB RBW.
Key Path
Initial S/W Revision
442
Meas Setup, Signal List, Mark Signals
Front panel only.
Yes
When the signal list is cleared, this value will reset to 0.
If the signal list is empty, =0
If the signal list is not empty, = number of peaks in signal list table
Saved in instrument state.
0
Number of peaks in signal list table.
A.07.00
Meas Setup, Signal List, Mark Signals
:CALCulate:FSCan:SLISt:MARK:SIGNal <integer>
CALC:FSC:SLIS:MARK:SIGN 4 Mark signal #4.
If the signal list contains no data, an error is generated and this function cannot be performed.
If the selected signal is not in the list, an error is generated and this function cannot be performed.
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
A.07.00
Meas Setup, Signal List, Mark Signals
A.13.00
EMI Receiver Mode Reference