Backwards Compatibility Scpi Commands - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Trace/ Detector
Backwards
Compatibility SCPI
Backwards Compatibility
SCPI Notes
Initial S/W Revision
Remote Command
Example
Notes
Preset

Backwards Compatibility SCPI commands

"Trace Display (Remote Command Only)" on page 588
"Detector Type (Remote Command Only)" on page 588
Trace Display (Remote Command Only)
This SCPI sets the trace's Update state.
Remote Command
Example
Notes
Backwards
Compatibility SCPI
Initial S/W Revision
Detector Type (Remote Command Only)
Select the detector used for the selected trace.
Remote Command
588
n* 4 bytes measurement results of trace 2 if trace 2 update is true; else return 0
n* 4 bytes measurement results of trace 3 if trace 3 update is true; else return 0
:TRACe[:DATA]?
This command is included for ESU compatibility. The SCPI is Meas Local and Context Sensitive.
A.07.00
TRACe:FEED:CONTrol ALWays|NEVer
TRACe:FEED:CONTrol?
TRAC:FEED:CONT ALW Allow block data transmission
This ESU command switches block data transmission during a scan on and off. The availability of
data is reported in the bit 9 of STATus:OPERation-Register.The block size depends on scan time.
NEVer
DISPlay[:WINDow]:TRACe[1]|2|3[:STATe] ON|OFF|1|0
DISPlay[:WINDow]:TRACe[1]|2|3[:STATe]?
DISP:TRAC OFF
DISP:TRAC?
This command is included for ESU compatibility. The suffix [1]|2 and [1]|2|3 are irrelevant to the
measurement, they are added solely for remote language compatibility. This SCPI alias to :TRACe[1]
|2|3:FSCan:UPDate ON|OFF|1|0.
DISPlay:WINDow[1]|2:TRACe[1]|2|3[:STATe]
A.07.00
[:SENSe]:DETector[1]|2|3[:FUNCtion] APEak | NEGative | POSitive |
SAMPle | RMS | AVERage | QPEak | CAVerage | CRMS
EMI Receiver Mode Reference