Data (Export) - Keysight x-series User Reference Manual

Data (Export)

Exporting a data file stores data from the current measurement to mass storage files. The Export Menu
only contains data types that are supported by the current measurement.
Since the commonly exported data files are in .csv format, the data can be edited by you prior to importing.
This allows youto export a data file, manipulate the data in Excel (the most common PC Application for
manipulating .csv files) and then import it.
Selecting an Export Data menu key will not actually cause the exporting to occur, since the analyzer still
needs to know where you wish to save the data. Pressing the Save As key in this menu brings up the Save
As dialog and Save As menu that allows you to specify the destination file and directory. Once a filename
has been selected or entered in the Open menu, the export will occur as soon as the Save key is pressed.
Key Path
Mode
Notes
Dependencies
Preset
Readback
Initial S/W Revision
Amplitude Correction
Pressing this key selects Amplitude Corrections as the data type to be exported. Pressing this key again
brings up the Select Menu, which allows the user to select which Amplitude Correction to save.
Amplitude Corrections are fully discussed in the documentation of the Input/Output key, under the
Corrections softkey.
See "Correction Data File " on page 546
Key Path
Remote Command
Example
Notes
EMI Receiver Mode Reference
Save
All
The menu is built from whatever data types are available for the mode. So the key locations in the
sub menu will vary.
No SCPI command directly controls the Data Type that this key controls. The Data Type is included in
the MMEM:STORe commands.
If a file type is not used by a certain measurement, that type is grayed out for that measurement. The
key for a file type will not show at all if there are no measurements in the Mode that support it.
Is not affected by a Preset or shutdown, but is reset during Restore Mode Defaults
The data type that is currently selected
Prior to A.02.00
Save
:MMEMory:STORe:CORRection 1|2|3|4|5|6, <filename>
:MMEM:STOR:CORR 2 "myAmpcor.csv" saves Correction 2 to the file myAmpcor.csv on the current
path.
The default path is My Documents\amplitudeCorrections.
If the save is initiated via SCPI, and the file already exists, the file will be overwritten.
Using the C: drive is strongly discouraged, since it runs the risk of being overwritten during an
instrument software upgrade.
Both single and double quotes are supported for any filename parameter over SCPI.
8 Frequency Scan Measurement
Save
545