Disturbance Level- E Limit (Remote Command Only, Scpi Standard Compatibility) - Keysight x-series User Reference Manual

11 APD Measurement
Meas Setup

Disturbance Level- E limit (Remote Command Only, SCPI standard compatibility)

Defines a list of disturbance values for a given limit line. Up to 200 points may be defined for each limit. The
limit defined in this SCPI is enabled when APD method is set to Disturbance Level (CALCulate:APD:LLINe
[1]:METHod DLEVel). The units default to the current amplitude axis unit (X Axis) and the range is –200 dBm
to +100 dBm.
The points query returns the number of points in the amplitude list. It will not be possible to turn on the limit
line unless the number of points in the control matches the number of points in the amplitude.
The points query returns the number of points in the amplitude list. It should match the number of points in
the control, that is, the number of values for the CONTrol axis and for the corresponding limit lines must be
identical. If one array is larger than the other, the limit trace is built using only as much data as is contained
in the smaller array.
An empty array returns the system error "list is empty" to a data query, 0 to a POINts query.
Remote Command
Example
Preset
State Saved
Initial S/W Revision
Remote Command
Example
Preset
State Saved
Initial S/W Revision
Probability of Time- ρ limit (Remote Command Only, SCPI standard compatibility)
Defines a list of probability values for a given limit line. Up to 200 points may be defined for each limit. The
limit defined in this SCPI is enabled when APD method is set to Probability of Time (CALCulate:APD:LLINe
[1]:METHod PROBability).
The points query returns the number of points in the amplitude list. It will not be possible to turn on the limit
line unless the number of points in the control matches the number of points in the amplitude.
The points query returns the number of points in the amplitude list. It should match the number of points in
the control, that is, the number of values for the CONTrol axis and for the corresponding limit lines must be
identical. If one array is larger than the other, the limit trace is built using only as much data as is contained
in the smaller array.
952
:CALCulate:APD:LLINe[1]:DLEVel[:DATA] <ampl>, <ampl>, ...
:CALCulate:APD:LLINe[1]:DLEVel[:DATA]?
:CALC:APD:LLIN:DLEV:DATA –10, –10, –20, –20
describes the amplitude values of limit line
Limit line data is cleared by Restore Mode Defaults.
Saved in instrument state.
A.13.00
:CALCulate:APD:LLINe[1]:DLEVel:POINts?
:CALC:APD:LLIN:DLEV:POIN? returns the number of points in the Disturbance Level limit line.
Upper Limit line data/points are cleared by Restore Mode Defaults.
Saved in instrument state.
A.13.00
EMI Receiver Mode Reference