By Det Amptd Type - Keysight x-series User Reference Manual

By Det Amptd Type

Specifies that the elements in the signal list will be sorted based on the detector amplitude type.
Key Path
Remote Command
Example
Dependencies
Couplings
Preset
State Saved
Range
Initial S/W Revision
By Δ Detector Type
Specifies that the elements in the signal list will be sorted based on the detector to limit delta type.
Key Path
Remote Command
Example
Dependencies
Couplings
Preset
State Saved
Range
Initial S/W Revision
EMI Receiver Mode Reference
Meas Setup, Signal List, Sort Signals, By Detector Amplitude
:CALCulate:FSCan:SLISt:SORT:DAMPlitude DET1|DET2|DET3
:CALCulate:FSCan:SLISt:SORT:DAMPlitude ?
CALC:FSC:SLIS:SORT:DAMP DET2
CALC:FSC:SLIS:SORT:DAMP?
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
Selecting the detector amplitude type to be sorted (pressing the key or sending the equivalent SCPI
command) will turn on the Auto Sort state, even if that detector amplitude type was already
selected.
DET1
Saved in instrument state.
Detector 1|Detector 2|Detector 3
A.07.00
Meas Setup, Signal List, Sort Signals, By ∆ Detector
:CALCulate:FSCan:SLISt:SORT:DLDelta DET1|DET2|DET3
:CALCulate:FSCan:SLISt:SORT:DLDelta?
CALC:FSC:SLIS:SORT:DLD DET2
CALC:FSC:SLIS:SORT:DLD?
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
Selecting the ∆ Detector type to be sorted (pressing the key or sending the equivalent SCPI
command) will turn on the Auto Sort state, even if that ∆ Detector type was already selected.
DET1
Saved in instrument state.
Detector 1|Detector 2|Detector 3
A.07.00
8 Frequency Scan Measurement
Meas Setup
449