Freq À Signal (Replace) - Keysight x-series User Reference Manual

11 APD Measurement
FREQ Channel
Key Path
Remote Command
Example
Notes
Preset
State Saved
Min
Max
Default Unit
Status Bits/OPC
dependencies
Initial S/W Revision
Freq à Signal (Replace)
Replaces the frequency of the selected signal with the set Frequency. Trace, Disturbance level (E meas),
Probability of Time (ρ meas) and Delta To Limit values will be shown as "--" to indicate that those values
are undefined. TimeStamp will be updated. Signal list will be re-sorted based on the auto sort setting.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
Freq à List (Append)
Append the set Frequency to the signal list. Trace, Disturbance level (E meas), Probability of Time (ρ meas)
and Delta To Limit values will be shown as "--"to indicate that those values are undefined.
916
FREQ Channel
[:SENSe]:FREQuency:CENTer:STEP[:INCRement] <freq>
[:SENSe]:FREQuency:CENTer:STEP[:INCRement]?
[:SENSe]:FREQuency:CENTer:STEP:AUTO OFF|ON|0|1
[:SENSe]:FREQuency:CENTer:STEP:AUTO?
FREQ:CENT:STEP:AUTO ON
FREQ:CENT:STEP 500 MHz
FREQ:CENT UP increases the current center frequency value by 500 MHz
FREQ:CENT:STEP?
FREQ:CENT:STEP:AUTO?
Preset and Max values are dependent on Hardware Options (503, 508, 513, 526)
Auto
ON
Saved in instrument state
– ( the maximum frequency of the instrument). (that is, a 27 GHz max freq instrument has a CF step
range of +/– 27 GHz)
The maximum frequency of the instrument. (that is, a 27 GHz max freq instrument has a CF step
range of +/– 27 GHz)
Hz
non-overlapped
A.07.00
FREQ Channel
:CALCulate:APD:SLISt:REPLace <integer>
CALC:APD:SLIS:REPL 2 Replace Signal #2 with Freq
If the signal list contains no data, an error is generated and this function cannot be performed.
If the selected signal is not in the list, an error is generated and this function cannot be performed.
A.13.00
EMI Receiver Mode Reference