Scan And Search - Keysight x-series User Reference Manual

Remote Command
Example
Notes

Scan and Search

When this key is selected, pressing Start performs a scan and search. See Section
page 471 for more information.
Key Path
Example
Dependencies
Initial S/W Revision
Search and Measure
When this key is selected, pressing Start performs a search and a final measurement,. See Section
Sequence" on page 471.
Key Path
Example
Dependencies
Initial S/W Revision
Remeasure Type
Specifies the remeasure type, either on all signals, a current signal, or the marked signal in the peak list.
Key Path
Remote Command
Example
Notes
EMI Receiver Mode Reference
INITiate[1]|2:EMITest
INIT:EMIT
This command is included for ESU compatibility. The suffix [1]|2 is irrelevant to the measurement,
they are added solely for remote language compatibility
This ESU Command is alias to FSC:SEQ SSAM;INIT
Meas Setup, Scan Sequence
FSC:SEQ SAS
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
A.07.00
Meas Setup, Scan Sequence
FSC:SEQ SAM
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
A.07.00
Meas Setup, Scan Sequence, Remeasure
[:SENSe]:FSCan:SEQuence:REMeasure CURRent|MARKed|ALL
[:SENSe]:FSCan:SEQuence:REMeasure?
FSC:SEQ:REM MARK
If "Marked" is selected but no marked signal is found in the signal list, an error is generated and
Remeasure cannot be performed.
8 Frequency Scan Measurement
Meas Setup
"Scan Sequence" on
"Scan
475