Trigger Level - Keysight x-series User Reference Manual

State Saved
Status Bits/OPC
dependencies
Initial S/W Revision
Modified at S/W Revision

Trigger Level

Sets the value where the external 2 trigger input will trigger a new sweep/measurement.
Key Path
Remote Command
Example
Couplings
Preset
State Saved
Min
Max
Default Unit
Backwards
Compatibility SCPI
Initial S/W Revision
Trig Slope
Controls the trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on a falling
edge.
Key Path
Remote Command
Example
Couplings
EMI Receiver Mode Reference
Saved in instrument state
The Status Operation Register bit 5 "Waiting for Trigger" is set at the same time as the Sweeping or
Measuring bit is set. It is cleared when the trigger actually occurs (that is, after the trigger event
occurs and all the applicable trigger criteria have been met). A corresponding pop-up message
("Waiting for trigger") is generated if no trigger signal appears after approximately 2 sec. This
message goes away when a trigger signal appears.
Prior to A.02.00
A.03.00
Trigger, External 2
:TRIGger[:SEQuence]:EXTernal2:LEVel
:TRIGger[:SEQuence]:EXTernal2:LEVel?
TRIG:EXT2:LEV 1.1 V
This same level is used for the Ext2 trigger source in the Trigger menu, for the Ext2 selection in the
Periodic Timer sync source (in the Trigger menu and in the Gate Source menu), and also for the Ext2
selection in the Gate Source menu.
1.2 V
Saved in instrument state
–5 V
5 V
V
:TRIGger[:SEQuence]:FRAMe:EXTernal2:LEVel
Prior to A.02.00
Trigger, External 2
:TRIGger[:SEQuence]:EXTernal2:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:EXTernal2:SLOPe?
TRIG:EXT2:SLOP NEG
This same slope is used in the Ext2 selection for the trigger source in the Trigger menu and for the
period timer sync source (in the Trigger menu and in the Gate Source menu).
7 Trigger Functions
Trigger
373