Scan Table - Keysight x-series User Reference Manual

Scan Table

Selects the scan table as the data type to be imported.
Key Path
Remote Command
Example
Notes
Couplings
Status Bits/OPC
Dependencies
Initial S/W Revision
Open...
When you press "Open", the analyzer brings up a Windows dialog and a menu entitled "File Open." This
menu allows you to navigate to the various fields in the Windows dialog without using a keyboard or
mouse. The Tab and Arrow keys can also be used for dialog navigation.
See "From File..." on page
Key Path
Notes
Initial S/W Revision
State
Most of the functions under this key work the same way in many measurements, so they are documented
in the Utility Functions section. For details about this key, see
Data (Import)
Most of the functions under this key work the same way in many measurements, so they are documented
in the Utility Functions section. For details about this key, see
Amplitude Correction
Most of the functions under this key work the same way in many measurements. For details about this key,
see "Amplitude Correction " on page
EMI Receiver Mode Reference
Recall, Data
:MMEMory:LOAD:SCAN <filename>
MMEM:LOAD:SCAN "myScanTable1.csv"
Imports the Scan Table from the file myScanTable1.csv in the default path.
If the file is empty, error –250.3005 is reported. If the file does not exist error –256 is reported. If
there is a mismatch between the file and the destination data type, an error is reported. –250.3003.
Then return to the Import Data menu and File Open dialog goes away.
Before loading a signal list file, any running scan sequence will be stopped.
No
Sequential - aborts the current measurement
A.07.00
1083in Recall, State, for a full description of this dialog and menu.
Recall, Data
The key location is mode-dependent and will vary.
Brings up Open dialog for recalling a <mode specific> Save Type
Prior to A.02.00
1087.
8 Frequency Scan Measurement
"State" on page 1081.
"Data (Import)" on page
Recall
1086.
533