Center Presel On/Off - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Marker Function
Key Path
Remote Command
Example
Notes
Dependencies
Preset
State Saved
Range
Initial S/W Revision

Center Presel On/Off

Controls the automatic centering of the preselector for the Measure at Marker function.
When Center Presel is On, the first step in performing the Measure at Marker function is to perform a
Presel Center. This is not performed if the microwave preselector is off, or the selected marker's frequency
is below Band 1. If the function is not performed, no message is generated.
Key Path
Remote Command
Example
Dependencies
Preset
State Saved
Range
Initial S/W Revision
Marker Zoom
Zooms the graticule display at the selected marker to10% of current span.
Key Path
Remote Command
Example
422
Meas Setup, Detectors (Measure)
[:SENSe]:FSCan:FINal:DETector[1]|2|3:LDELta <limit Num>
[:SENSe]:FSCan:FINal:DETector[1]|2|3:LDELta?
:FSC:FIN:DET3:LDEL 2 Set limit line 2 to be used by detector 3.
Not affected by Mode Preset, preset by Restore Mode Defaults.
This key is grayed out during final measurement. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
1|1|1
Saved in instrument state.
1|2|3|4|5|6
A.07.00
Marker Function
:CALCulate:FSCan:MAMarker:PCENter ON|OFF|1|0
:CALCulate:FSCan:MAMarker:PCENter?
CALC:FSC:MAM:PCEN ON
Blank in some non MXE instruments that do not include a preselector, such as MXA with option 503.
If a SCPI command is sent to these instruments, it is accepted without error, and the query always
returns 0.
ON
Saved in instrument state
ON|OFF
A.07.00
Marker Function
:CALCulate:FSCan:MARKer[1]|2|...|12:FUNCtion:ZOOM
CALC:FSC:MARK2:FUNC:ZOOM Perform marker zoom at Marker 2.
EMI Receiver Mode Reference