Refresh - Keysight x-series User Reference Manual

Key Path
Mode
Remote Command
Example
Preset
State Saved
Range
Initial S/W Revision

Refresh

When pressed, refreshes the Show Errors display.
Key Path
Initial S/W Revision
Clear Error Queue
This clears all errors in all error queues.
Note the following:
• Clear Error Queue does not affect the current status conditions.
• Mode Preset does not clear the error queue.
• Restore System Defaults will clear all error queues.
• *CLS only clears the queue if it is sent remotely and *RST does not affect any error queue.
• Switching modes does not affect any error queues.
Key Path
Initial S/W Revision
Status
See "History" on page 274.
Input Overload Enable (Remote Command Only)
Input Overload errors are reported using the Input Overload status bit (bit 12 in the Measurement Integrity
status register). Input Overloads (for example, ADC Overload errors) can come and go with great
frequency, generating many error events (for example, for signals just on the verge of overload), and so are
EMI Receiver Mode Reference
System, Show, Errors
All
:SYSTem:ERRor:VERBose OFF|ON|0|1
:SYSTem:ERRor:VERBose?
:SYST:ERR:VERB ON
This is unaffected by Preset but is set to OFF on a "Restore System Defaults->Misc"
No
On | Off
Prior to A.02.00
System, Show, Errors
Prior to A.02.00
System, Show, Errors
Prior to A.02.00
6 System Functions
System
275