Operation Positive Transition - Keysight x-series User Reference Manual

Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision

Operation Positive Transition

This command determines which bits in the Operation Condition register will set the corresponding bit in
the Operation Event register when the condition register bit has a positive transition (0 to 1). The variable
<integer> is the sum of the decimal values of the bits that you want to enable.
Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision
Preset the Status Byte
Sets bits in most of the enable and transition registers to their default state. It presets all the Transition
Filters, Enable Registers, and the Error/Event Queue Enable. It has no effect on Event Registers,
Error/Event QUEue, IEEE 488.2 ESE, and SRE Registers as described in IEEE Standard 488.2–1992, IEEE
Standard Codes, Formats, Protocols, and Common Commands for Use with ANSI/IEEE Std 488.1–1987.
New York, NY, 1992.
Remote Command
Example
Initial S/W Revision
EMI Receiver Mode Reference
All
:STATus:OPERation:NTRansition <integer>
:STATus:OPERation:NTRansition?
STAT:OPER:NTR 1 Align Now operation complete will be reported to the Status Byte Register.
0
0
32767
Sequential command
Prior to A.02.00
All
:STATus:OPERation:PTRansition <integer>
:STATus:OPERation:PTRansition?
STAT:OPER:PTR 1 Align Now operation beginning will be reported to the Status Byte Register.
32767
0
32767
Sequential command
Prior to A.02.00
:STATus:PRESet
STAT:PRES
Prior to A.02.00
3 Programming the Analyzer
STATus Subsystem
113