Clear All - Keysight x-series User Reference Manual

10 Monitor Spectrum Measurement
Meas Setup

Clear All

Clears all the marks from the signal list.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
Delete Signals
This key opens the delete signals option menu.
Key Path
Initial S/W Revision
Select Signal
Specifies the selected signal. The term "Selected signal" is used throughout this document to specify
which signal will be affected by the functions.
Key Path
Notes
Dependencies
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision
Delete Signal
Deletes the selected signal. If you accessed this function from the front panel, the following message will
prompt you for confirmation to delete the selected signal from the signal list.
This will delete the selected signal. Are you sure you want to do this?
Please press Enter or OK to proceed. Press ESC or Cancel to close this dialog.
784
Meas Setup, Signal List, Mark Signals
:CALCulate:SLISt:MARK:CLEar:ALL
CALC:SLIS:MARK:CLE:ALL Clear mark from all signals.
If the signal list contains no data, an error is generated and this function cannot be performed.
A.13.00
Meas Setup, Signal List
A.13.00
Meas Setup, Signal List, Delete Signals
Front panel only.
Yes
When the signal list is cleared, this value will reset to 0.
If the signal list is empty, =0
If the signal list is not empty, = number of peaks in signal list table
Saved in instrument state
0
Number of peaks in signal list table.
A.13.00
EMI Receiver Mode Reference