Click Count - Keysight x-series User Reference Manual

12 Disturbance Analyzer Measurement
Meas Setup
Preset
State Saved
Min
Max
Initial S/W Revision

Click Count

When turned on, specifies the Click Count value for the test to stop when the measured clicks is equal or
more than the entered clicks limit number.
Key Path
Remote Command
Example
Preset
State Saved
Min
Max
Initial S/W Revision
By Δ Detector Type
Specifies that the elements in the signal list will be sorted based on the detector to limit delta type.
Key Path
Remote Command
Example
Dependencies
1070
DAN:CLIC:CORR?
0
Saved in instrument state
–100 dB
100 dB
A.14.00
Meas Setup, Frequency
[:SENSe]:DANalyzer:CLICk:COUNt <integer>
[:SENSe]:DANalyzer:CLICk:COUNt?
[:SENSe]:DANalyzer:CLICk:COUNt:STATe ON|OFF|1|0
[:SENSe]:DANalyzer:CLICk:COUNt:STATe?
DAN:CLIC:COUN 10
DAN:CLIC:COUN?
DAN:CLIC:COUNt:STAT OFF
40
OFF
Saved in instrument state
1
1000
A.14.00
Meas Setup, Signal List, Sort Signals, By ∆ Detector
:CALCulate:FSCan:SLISt:SORT:DLDelta DET1|DET2|DET3
:CALCulate:FSCan:SLISt:SORT:DLDelta?
CALC:FSC:SLIS:SORT:DLD DET2
CALC:FSC:SLIS:SORT:DLD?
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
EMI Receiver Mode Reference