Properties - Keysight x-series User Reference Manual

Preset
State Saved
Range
Backwards
Compatibility SCPI
Backwards Compatibility
SCPI Notes
Initial S/W Revision

Properties

Accesses a menu that lets you set the properties of the selected limit.
Key Path
Initial S/W Revision
Select Limit
Specifies the selected limit. The term "selected limit" is used throughout this document to specify which
limit will be affected by the functions.
Key Path
Notes
Preset
State Saved
Initial S/W Revision
Test Trace
Selects the trace that you want the limit to test. A limit is applied to one and only one trace.
A trace can have multiple limit lines simultaneously; in that case, only one upper limit line will affect the
color of the trace. Other limit lines will be displayed, and will affect the pass/fail status, but the trace will
not turn red if it crosses a secondary limit line.
Key Path
Remote Command
Example
Notes
EMI Receiver Mode Reference
OFF
Saved in instrument state
On|Off
:CALCulate[1]|2:LIMit[1]|2|...|6:STATe
This command above is included for ESU compatibility. The suffix [1]|2 is irrelevant to the
measurement, they are added solely for remote language compatibility.
A.13.00
Meas Setup, Limits
A.13.00
Meas Setup, Limits
Front panel only. The selected limit is remembered even when not in the Limit Menu.
Limit 1, not affected by Mode Preset, preset by Restore Mode Defaults.
Saved in instrument state
A.13.00
Meas Setup, Limits, Properties
:CALCulate:LLINe[1]|2|...|6:TRACe 1|2|3
:CALCulate:LLINe[1]|2|...|6:TRACe?
CALC:LLIN3:TRAC 2 Applies limit 3 to trace 2.
When the trace display is off, the trace is not tested. The trace is tested only when the trace display
is on and Test Limits (see "Test Limits (All Limits)" on page
10 Monitor Spectrum Measurement
801) is on.
Meas Setup
791