Questionable Integrity Negative Transition - Keysight x-series User Reference Manual

Questionable Integrity Negative Transition

This command determines which bits in the Questionable Integrity Condition register will set the
corresponding bit in the Questionable Integrity Event register when the condition register bit has a negative
transition (1 to 0)
The variable <integer> is the sum of the decimal values of the bits that you want to enable.
Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Integrity Positive Transition
This command determines which bits in the Questionable Integrity Condition register will set the
corresponding bit in the Questionable Integrity Event register when the condition register bit has a positive
transition (0 to 1). The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Integrity Signal Register
"Questionable Integrity Signal Condition" on page 130
EMI Receiver Mode Reference
All
:STATus:QUEStionable:INTegrity:NTRansition <integer>
:STATus:QUEStionable:INTegrity:NTRansition?
STAT:QUES:INT:NTR 8 Measurement 'regained calibration' Summary will be reported to the Integrity
Summary of the Status Questionable register.
0
0
32767
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:INTegrity:PTRansition <integer>
:STATus:QUEStionable:INTegrity:PTRansition?
STAT:QUES:INT:PTR 8 Measurement 'became uncalibrated' Summary will be reported to the
Integrity Summary of the Status Questionable register.
32767
0
32767
Sequential command
Prior to A.02.00
3 Programming the Analyzer
STATus Subsystem
129