Buffer Tuning Commands - Dell Z9500 Command Reference Manual

NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 7.7.1.0

Buffer Tuning Commands

This section describes the buffer tuning commands supported on the switch.
WARNING: Reconfiguring the buffer allocations is a sensitive operation. Do not use any buffer
tuning command without first contacting the Dell Networking Technical Assistance Center (TAC).
660
NO NO
portcardBoardRevisionTest: ALL
NO NO
portcardHiGigLinkStatusTest: ALL
NO NO
portcardIxiaTrafficCmd: ALL
NO YES
portcardPortStats: ALL
NO YES
portcardXELinkStatusTest: ALL
NO NO
qsfpOpticsTest: ALL
NO NO
qsfpPhyTest: ALL
NO NO
qsfpPresenceTest: ALL
NO NO
qsfpReadInterruptTest: ALL
NO YES
qsfpReadModeTest: ALL
NO YES
NO NO
sataSsdTest: ALL
NO NO
temperatureTest: ALL
NO NO
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced the verbose option.
Introduced on the S-Series.
RUN
RUN
RUN
RUN
RUN
RUN
RUN
RUN
RUN
RUN
rtcTest: ALL RUN
RUN
RUN
YES NO
NO YES
NO NO
NO NO
NO YES
YES YES
YES YES
NO YES
NO NO
NO NO
YES YES
YES YES
YES NO
Debugging and Diagnostics