Low-Pass Filter; Timing Diagram Of Pr Mode - Delta ASDA-A3 Series User Manual

Hide thumbs Also See for ASDA-A3 Series:

Table of Contents

Operation Mode

6.2.6 Low-pass filter

Refer to Chapter 8 for detailed descriptions of the relevant parameter.

In PR mode, the Position command is issued with the DI signals (POS0 – POS6 and CTRG) for

CN1. Refer to Section 6.2.2 for information about the DI signal and its selected register.

The timing diagrams are shown below.

Note: Cmd_OK is on when the PR command completes; TPOS is on when the error is smaller than value

set by P1.054; MC_OK is on when Cmd_OK and TPOS are both on.

Position command smoothing constant (low-pass filter)

Set the response time with

Ecm-a3 series