ASDA-A3
Motion Control
If the mark is on the non-compensation motion axis and when E-Cam phase alignment is
operating, the following mark position is unchanged. If the mark is on the compensation motion
axis and when E-Cam phase alignment is operating, the following mark position is changed, as
shown in Figure 7.3.7.19.
7
(a) Mark on the non-compensation motion axis (P2.076.X Bit 2 = 0)
(b) Mark on the compensation motion axis (P2.076.X Bit 2 = 1)
Figure 7.3.7.19 E-Cam phase alignment
7-131