Delta ASDA-A3 Series User Manual page 319

Motion Control
You can create the E-Cam curve table for intermittent printer by using the ASDA-Soft software.
Figure 7.3.7.14 shows the user setting interface. The printer specification settings are as
follows.
Gear ratio: set the number of motor gear teeth (A) and number of material feeder gear
1.
7
teeth (B).
Print length (PL) and blank length (BL): set the print length and blank length.
2.
Drive roll diameter (d1): set the drive roll diameter for conveying the material.
3.
Printing axis diameter (d2) and printing axis pulse number (N): set the diameter of master
4.
printing axis and number of pulses per revolution.
Number of PUU per motor revolution: set the number of PUU per motor revolution of the
5.
drive roll after E-Gear ratio conversion (P1.044 / P1.045).
The ratio of printing axis circumference to printing zone length (�� =
using E-Cam curves for intermittent printing machines in order to save the material. Calculate
the synchronous speed zone angle with the formula �� =
waiting zone angle and S-curve angle in the advanced settings. Increase the angle for the
synchronous speed zone to increase the zone size. This ensures the printing axis and drive roll
are in the uniform operation speed and stable during printing motions to achieve higher quality
printing.
7-122
����2
) must exceed 1 when
����+����
����
× 360°. You can also adjust the
����2
ASDA-A3