Avaya S8700 Maintenance Manual page 2074

Maintenance-Object Repair Procedures
Table 8-547. Test #16 DIG-LINE Station Lamp Updates Test — Continued
Error Test
Code Result Description / Recommendation
PASS The message to light every station lamp was sent successfully to the port.
1. Observe the station lamps being lit when running the test. If every lamps
2. Investigate by using other Digital Line port tests, and by examining the
Digital Station Audits Test (#17)
This is a series of six tests that are classified as audits. The media server sends
messages to the on-board microprocessor to perform the tests. These audits run
only if the station is in-service.
Switchhook Inquiry test
according to the circuit pack's records. This inquiry is sent all the way to
the voice terminal.
Bad Scan Inquiry test
generated count based on certain events relating to the link's conditions.
This indicates communications problems between the media server and
Digital Port circuit pack.
EPF/PTC Inquiry test
Electronic Power Feed (EPF). Possible conditions are: EPF-on-ok,
EPF-off.
ID Request test
returns its configuration information and health information. The
information is checked, and a pass/fail result is provided.
Ringer update
according to the media server's records.
DTMF Administration update
to refresh its default value (sending touch tones only) in the primary
information channel. This value is initially set when the station is put
in-service and each time the station's state changes from another state to
in-service.
8-1352 Issue 1 May 2002
does not light, the other Digital Line test results may indicate related
problems that do not allow the lamps to light.
station, wiring, and connections.
—
This updates the media server's records
—
This sends an up-link message containing a
—
This sends an up-link status message of the
—
This sends a status request to the station. The station
—
This updates the digital telephone's ringer state
Continued on next page
—
This sends the digital station a message
555-233-143