Avaya S8700 Maintenance Manual page 2088

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

System Technician-Demanded Tests:

Descriptions and Error Codes

Always investigate tests in the order presented in the table below when inspecting

errors in the system. For example, by clearing error codes associated with the

NPE Crosstalk test (#6), you may also clear errors generated from other tests in

the testing sequence.

Order of Investigation

Speech Synthesis PSS Handshake test (#168)

NPE Crosstalk test (#6)

Conference Circuit test (#7)

Speech Synthesis DTMF Receiver test (#163)

Speech Synthesis Memory test (#166)

Speech Synthesis DSP Tone test (#165)

Speech Synthesis SSD Inquiry test (#167)

Speech Synthesis DTMF Receiver Inquiry test (#164)

Speech Synthesis Parameter Update test (#169)

D = Destructive, ND = Nondestructive

NPE Crosstalk Test (#6)

The NPE Crosstalk test verifies that this port's NPE channel talks on the selected

time slot and never crosses over to time slots reserved for other connections. If

the NPE is not working correctly, one-way and noisy connections may occur. This

test is usually only part of a port's long test sequence and takes about 20 to 30

seconds to complete.

Table 8-556. TEST #6 NPE Crosstalk Test

Description / Recommendation

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

System resources required to run this test are not available. The port may be

busy with a valid call and therefore unavailable for certain tests. Wait until the

port is idle (amber LED is off) before retesting.

1. If the port is idle, retry the command at 1-minute intervals up to 5 times.

Issue 1 May 2002

Continued on next page

Troubleshooting