Avaya S8700 Maintenance Manual page 2101

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

SN-CONF (Switch Node Configuration)

h. The SNI is administered to be connected to a DS1C but is not.

To resolve this error, refer to FAIL code 139 for test 759.

i. The SNI is connected to a DS1C, but no DS1C is administered.

To resolve this error, refer to FAIL code 140 for test 759.

System Technician-Demanded Tests:

Descriptions and Error Codes

Always investigate tests in the order presented in the table below when inspecting

errors in the system. For example, by clearing error codes associated with the

Configuration audit (#759), you may also clear errors generated from other tests

in the testing sequence.

Order of Investigation

Configuration audit (#759)

Processor Route audit (#760)

D = Destructive, ND = Nondestructive

Configuration Audit (#759)

This test is nondestructive.

For descriptions of result codes for this test see:

''SNC-BD (Switch Node Clock Circuit Pack)''

a Switch Node Clock (circuit pack slots 10 or 12).

''SNI-BD (SNI Circuit Pack)''

Interface (circuit pack slots 2–9 or 13–20).

This test is run via the test board short or test board long command for SNI

circuit packs or SNC circuit packs.

For SNI circuit packs, this test queries the SNI for SNCs in the same switch node

carrier, SNI peers, DS1Cs, and EI or SNI neighbors that the SNI can

communicate with and compares this data to the administered data.

For SNC circuit packs, this test queries the SNC for SNCs and SNIs in the same

switch node carrier that the SNC can communicate with and compares this data to

the administered data.

Failures of this test cause entries in the error and alarm logs against Switch Node

Configuration (SN-CONF) with the board location of the SNI or SNC.

when the circuit pack tested is a Switch Node

when the circuit pack tested is

Issue 1 May 2002

Troubleshooting