Assigning Ospfv3 Process Id And Router Id Globally; Configuring Stub Areas; Configuring Passive-Interface - Dell Z9500 Configuration Manual

Z-series core and aggregation switche

Hide thumbs Also See for Z9500:

Table of Contents

– process-id: the process ID number assigned.

– area-id: the area ID for this interface.

Assigning OSPFv3 Process ID and Router ID Globally

To assign, disable, or reset OSPFv3 globally, use the following commands.

Enable the OSPFv3 process globally and enter OSPFv3 mode.

CONFIGURATION mode

ipv6 router ospf {process ID}

The range is from 0 to 65535.

Assign the router ID for this OSPFv3 process.

CONF-IPV6-ROUTER-OSPF mode

router-id {number}

– number: the IPv4 address.

The format is A.B.C.D.

Enter the router-id for an OSPFv3 router as an IPv4 IP address.

Disable OSPF.

CONFIGURATION mode

no ipv6 router ospf process-id

Reset the OSPFv3 process.

EXEC Privilege mode

clear ipv6 ospf process

To configure IPv6 stub areas, use the following command.

Configure the area as a stub area.

CONF-IPV6-ROUTER-OSPF mode

area area-id stub [no-summary]

– no-summary: use these keywords to prevent transmission in to the area of summary ASBR LSAs.

– Area ID: a number or IP address assigned when creating the area. You can represent the area ID as a number from 0 to

65536 if you assign a dotted decimal format rather than an IP address.

To suppress the interface's participation on an OSPFv3 interface, use the following command.

This command stops the router from sending updates on that interface.

Specify whether some or all some of the interfaces are passive.

CONF-IPV6-ROUTER-OSPF mode

passive-interface {interface-type}

Open Shortest Path First (OSPFv2 and OSPFv3)