Client (Radsecproxy-Srv) - Allied Telesis x510-28GTX Command Reference Manual

Stackable gigabit edge switches x510 series
Table of Contents

Advertisement

L
RADIUS S
C
OCAL
ERVER
OMMANDS
(
-
)
CLIENT
RADSECPROXY
SRV

client (radsecproxy-srv)

Overview
Use this command to add a RadSec client (for example, a NAS device) to the
RadSecProxy local-server application. The application will accept RADIUS requests
from all configured clients.
Use the no variant of this command to delete a previously-configured client from
the RadSecProxy local-server application.
client {<hostname>|<ip-addr>} [name-check {on|off}]
Syntax
no client {<hostname>|<ip-addr>}
Mode
RadSecProxy Local Server Configuration
Usage
The client may be specified by its domain name or by its IPv4 address. If a domain
name is used, it must be resolvable using a configured DNS name server.
Each client may be configured to use certificate name-checking; if not specified,
the global behavior defined by client name-check or no client name-check will
be used. If name checking is enabled, the Common Name portion of the subject
field of the client's X.509 certificate must match the domain name or IP address
specified in this command.
NOTE
client mutual-authentication
Example
To add a client called 'mynas.local' with certificate name checking off, use the
commands:
awplus#
awplus(config)#
awplus(config-radsecproxy-srv)#
off
Related
client mutual-authentication
Commands
client name-check
C613-50170-01 Rev B
Parameter
Description
<hostname>
Hostname of client.
<ip-addr>
Specify the client IPv4 address, in dotted decimal notation
(A.B.C.D).
name-check
Specify whether or not to enforce certificate name checking for
this client. If the parameter is not specified then the global
behavior, which defaults to on, is used.
on
off
: If mutual authentication is disabled then this parameter has no effect, see the
configure terminal
radius-secure-proxy local-server
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Enable name checking for this client.
Disable name checking for this client.
command.
client mynas.local name-check
1910

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents