Ping Mpls Ldp - Juniper JUNOS OS 10.3 - SOFTWARE Manual

ping mpls ldp

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
ping mpls ldp fec
<count count>
<destination address>
<detail>
<exp forwarding-class>
<instance routing-instance-name>
<logical-system (all | logical-system-name)>
<size bytes>
<source source-address>
<sweep>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
The size and sweep options were introduced in Junos OS Release 9.6.
The option was introduced in Junos OS Release 10.0.
instance
Check the operability of MPLS LDP-signaled label-switched path (LSP) connections.
Type Ctrl+c to interrupt a ping mpls
—(Optional) Number of ping requests to send. If
count count
requests are sent. The range of values is
.
5
destination address —(Optional) Specify an address other than the default (
for the ping echo requests. The address can be anything within the
—(Optional) Display detailed information about the echo requests sent and received.
detail
—(Optional) Value of the forwarding class for the MPLS ping packets.
exp forwarding-class
—Ping an LDP-signaled LSP using the forwarding equivalence class (FEC) prefix and
fec
length.
instance routing-instance-name
routing instance and forwarding equivalence class (FEC) associated with an LSP.
logical-system (all | logical-system-name)
systems or on the specified logical system.
—(Optional) Size of the label-switched path (LSP) ping request packet (
size bytes
through 65468 bytes). Packets are 4-byte aligned. For example, If you enter a size
of 89, 90, 91, or 92, the router or switch uses a size value of 92 bytes. If you enter a
packet size that is smaller than the minimum size, an error message is displayed
reminding you of the 88-byte minimum.
—(Optional) IP address of the outgoing interface. This address is
source source-address
sent in the IP source address field of the ping request. If this option is not specified,
the default address is usually the loopback interface (
Chapter 126: Operational Mode Commands for MPLS
command.
1 through 1,000,000
—(Optional) Allows you to ping a combination of the
—(Optional) Perform this operation on all logical
is not specified, five ping
count
. The default value is
127.0.0.1/32
subnet.
127/8
88
lo.0 ).
3445
)