Figure 238. Burst Mode Emulation Example; Figure 239. Carrier Frequency Signal Insertion - ST STM32G4 Series Reference Manual

Advanced arm-based 32-bit mcus

Hide thumbs Also See for STM32G4 Series:

Table of Contents

High-resolution timer (HRTIM)

CMP1xR = 0x0800

A high-frequency carrier can be added on top of the timing unit output signals to drive

isolation transformers. This is done in the output stage before the polarity insertion, as

chopper on outputs 1 and 2, respectively.

Figure 238. Burst mode emulation example

239, using CHP1 and CHP2 bits in the HRTIM_OUTxR register, to enable

CMP1xR = 0x0000

IDLE (emulated)

Fault / Idle sources

RM0440 Rev 1

CMP1xR = 0x0800

Table of Contents

Do you have a question about the STM32G4 Series and is the answer not in the manual?