ST STM32G4 Series Reference Manual page 669

Advanced arm-based 32-bit mcus

Hide thumbs Also See for STM32G4 Series:

Table of Contents

Bits 31:27 JSQ4[4:0]: 4th conversion in the injected sequence

Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that

Bit 26 Reserved, must be kept at reset value.

Bits 25:21 JSQ3[4:0]: 3rd conversion in the injected sequence

Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that

Bit 20 Reserved, must be kept at reset value.

Bits 19:15 JSQ2[4:0]: 2nd conversion in the injected sequence

Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that

Bit 14 Reserved, must be kept at reset value.

Bits 13:9 JSQ1[4:0]: 1st conversion in the injected sequence

Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that

These bits are written by software with the channel number (0..18) assigned as the 4th in the

injected conversion sequence.c

no injected conversion is ongoing).

These bits are written by software with the channel number (0..18) assigned as the 3rd in the

injected conversion sequence.

no injected conversion is ongoing).

These bits are written by software with the channel number (0..18) assigned as the 2nd in

the injected conversion sequence.

no injected conversion is ongoing).

These bits are written by software with the channel number (0..18) assigned as the 1st in the

injected conversion sequence.

no injected conversion is ongoing).

RM0440 Rev 1

Analog-to-digital converters (ADC)

Chapters

Table of Contents

Do you have a question about the STM32G4 Series and is the answer not in the manual?