07/11/02 09:15:22 61TA0000_110_0317
13. Check for continuity between rocker arm oil
pressure switch B 2P connector terminal No. 1 and
PCM connector terminal B43.
*03
ROCKER ARM OIL PRESSURE SWITCH B 2P CONNECTOR
Is there continuity?
YES
terminals at rocker arm oil pressure switch B,
rocker arm oil control solenoid B, and the PCM. If it
is OK, go to step 35.
−
NO
oil pressure switch B and the PCM (B43), then go to
step 29.
14. Turn the ignition switch to LOCK (0).
15. Disconnect the rocker arm oil pressure switch B 2P
connector.
VTPSWB (BLU)
Terminal side of female terminals
PCM CONNECTOR B (49P)
VTPSWB (BLU)
Terminal side of female terminals
−
Check for poor connections or loose
Repair open in the wire between rocker arm
16. Turn the ignition switch to ON (II).
17. Check the ROCKER ARM OIL PRESSURE SWITCH B
in the DATA LIST with the HDS.
Is SW IT CH ON indicated?
YES
−
Go to step 24.
−
NO
Go to step 18.
18. Turn the ignition switch to LOCK (0).
19. Remove rocker arm oil pressure switch B (see page
11-330), then reinstall the rocker arm oil control
valve and its filter (see page 11-328) without
installing rocker arm oil pressure switch B.
20. Attach the special tools to the rocker arm oil control
valve as shown, then attach rocker arm oil pressure
switch B to the oil pressure gauge adapter (A).
07406-0020201 or
07MAJ-PY4011A and
07406-0070301
07MAJ-PY40120
21. Reconnect the rocker arm oil pressure switch B 2P
connector.
B
22 N·m
(2.2 kgf·m,
16 lbf·ft)
A
07NAJ-P07010A
07ZAJ-S5AA200
(cont'd)
11-317
*04