Debugging And Diagnostics - Dell Z9500 Command Reference Manual

Debugging and Diagnostics

The debugging and diagnostics commands are supported on the Dell Networking OS platform.
This chapter contains the following sections:
• Diagnostics and Monitoring Commands
• Offline Diagnostic Commands
• Buffer Tuning Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the
logging coredump
Enable a core dump.
Syntax
logging coredump {cp | linecard {slot-number |all} } rps}
Parameters
cp
linecard
rps
Defaults The kernal core dump is enabled by default for the Route Processor (RP 1 and 2 on
the E-Series). The kernel core dump for the Control Processor and application core
dump are disabled on all systems by default.
Command CONFIGURATION
Modes
Command
Version 9.7(0.0)
History
Version
8.3.19.0
Version 8.3.11.1
646
Control and Monitoring
Enter a core dump for the Control Processor.
Enter a core dump for a line card.
Enter a core dump for Route Processor 1 or 2.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
chapter.
Debugging and Diagnostics
12