Honda ACCORD HYBRID 2005 Service Manual page 1014

Automatic Transmission
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
11. Disconnect the solenoid harness connector.
12. Check for continuity between PCM connector
terminal C2 and solenoid harness connector
terminal No. 1.
SOLENOID H A R N E S S PCM C O N N E C T O R C (22P)
CONNECTOR
SH D (GRN/RED)
1 2 3 4
/
SH D (GRN/RED)
1 2
U
3 4 5 6 7
8 9 10 11 12 13 14 15
16 17 18 19 20
n 21 22
W i r e side of f e m a l e t e r m i n a l s
Is there continuity?
Y E S — G o t o step 13.
NO—Repair an open in the w i r e between PCM
connector terminal C2 and the solenoid harness
connector, then go to step 15.
13. Remove the solenoid harness connector (see page
14-206).
14. Check for continuity between solenoid harness
connector terminal No. 1 and shift solenoid valve D
connector t e r m i n a l .
S O L E N O I D H A R N E S S C O N N E C T O R
1 2 3 4
SH D (ORN)
T e r m i n a l side of
M \ male t e r m i n a l s
SHIFT S O L E N O I D
V A L V E D
C O N N E C T O R
W i r e side of f e m a l e t e r m i n a l s
Is there continuity?
YES—Replace shift solenoid valve D (see page
14-206), then go to step 15.
NO—Replace the solenoid harness (see page
14-206), then go to step 15.
15. Clear the DTC w i t h the HDS.
16. Test-drive the vehicle for several minutes in the D
position in all five gears.
17. Monitor the OBD status for P0983 in the DTCs/
Freeze Data in A/T M o d e M e n u for a pass/fail.
Does the result indicate a pass?
YES—The p r o b l e m has been corrected. •
NO—Return to step 7 and recheck.
14-178