Honda ACCORD HYBRID 2005 Service Manual page 685

How to Troubleshoot Circuits at the MCM
Special Tools Required
• Digital multimeter KS-AHM-32-003 (1) or a
c o m m e r c i a l l y available digital m u l t i m e t e r
• Backprobe set 07SAZ-001000A (2)
If DTC troubleshooting requires voltage or resistance
checks at the M C M connectors, remove the M C M and
test i t
1. Remove the IPU lid (see page 12-140).
2. Remove the harness holder (A), the M C M relay (B),
and the clip (C).
9.8
N-m
(1.0 k g f m , 7.2 Ibf-ft)
3. Remove the bolts (D), disconnect g r o u n d bolt (E),
and then raise the M C M (F).
4. Connect the backprobe adapters (A) to the stacking
patch cords (B), and connect the cords to a digital
multimeter.
5. Using the w i r e insulation as a guide for the
contoured tip of the backprobe adapter, gently slide
the tip into the connector f r o m the w i r e side until it
touches the end of the w i r e t e r m i n a l .
(cont'd)
12-7