Honda ACCORD HYBRID 2005 Service Manual page 1057

A / T C l u t c h P r e s s u r e C o n t r o l S o l e n o i d V a l v e C R e p l a c e m e n t
1. Remove the intake air duct and air cleaner housing.
2. Disconnect the A/T clutch pressure control solenoid
valve connector.
3. Remove the A/T clutch pressure control solenoid
valve C.
4. Remove the ATF joint pipes, O-rings, ATF pipe, and
gasket.
5. Clean the m o u n t i n g surfaces and the fluid passages
of the solenoid valve body and the transmission
housing.
6. Install the 8 x 53 m m ATF joint pipe (A) w i t h the
filter side into its m o u n t i n g hole (B).
Check the height (A) of the 8 x 53 m m ATF joint
pipe (B) between the top (C) of the pipe and the
solenoid valve body m o u n t i n g surface (D). The
height is about 7 m m (0.3 in.) If the height is over
7 m m (0.3 in.), push the pipe until it b o t t o m s in the
accumulator body.
(cont'd)
14-221