Honda ACCORD HYBRID 2005 Service Manual page 1158

Shafts and Clutches
S e c o n d a r y S h a f t R e a s s e m b l y ( c o n t ' d )
8. Install the new splined w a s h e r (A) w i t h the marked
side (B) up over the ball bearing w i t h the special
tools and a press.
07746-0030100
07746-0030300
9. Install the new locknut (A).
10. Place a V-block (A) on a vise (B), and put the
secondary shaft (C) on the V-block and vise.
07XAA-002010A
11. Attach the special tool onto the 1st clutch guide,
and secure the special tool w i t h the vise to hold the
secondary shaft. Tighten the locknut to 178 N-m
(18.2 kgf-m, 132 I b f f t ) w i t h the torque w r e n c h (D).
NOTE:
• Use a t o r q u e w r e n c h to tighten the locknut. Do
not use an impact w r e n c h .
• The locknut has left-hand threads.
12. Stake the locknut into its shaft in depth (A) of 0.7 —
1.3 m m (0.03—0.05 in.) using a 3.5 m m punch (B).
14-322