Honda ACCORD HYBRID 2005 Service Manual page 1157

0®
S e c o n d a r y S h a f t R e a s s e m b l y
Special Tools Required
• Driver, 40 m m I.D. 07746-0030100
• Attachment, 30 m m I.D. 07746-0030300
• Wrench 40 x 42 m m 07XAA-002010A
1. Install the thrust needle bearing (A), needle bearing
(B), 2nd gear/park gear (C), thrust needle bearing
(D), and splined washer (E) in the direction s h o w n
on the secondary shaft (F).
2. W r a p the shaft splines w i t h tape, and install the
n e w O-rings (G) in 2nd clutch O-ring grooves, then
remove the tape.
NOTE: To prevent damage to the O-rings, be sure
to install the O-rings after installing the splined
washer.
3. Install the 2nd clutch (H) on the secondary shaft,
and secure the 2nd clutch w i t h the snap ring (I).
4. Install the idler gear (J) in the direction s h o w n ,
thrust needle bearing (K), 1st gear collar (L), needle
bearing (M), 1st gear assembly (N), thrust needle
bearing (O), and 52 m m washer (P) in the direction
s h o w n on the secondary shaft.
5. W r a p the shaft splines w i t h tape, and install the
new O-rings (Q) in 1st/1st-hold clutch O-ring
grooves, then remove the tape.
NOTE: To prevent damage to the O-rings, be sure
to install the O-rings after installing the 1st gear
collar and 52 m m washer.
6. Install the 1st/1st-hold clutch (R).
7. Install the ball bearing (S) over the 1st/1st-hold
clutch guide w i t h the special tools and a press.
07746-0030100
0 7 7 4 6 - 0 0 3 0 3 0 0
(cont'd)
14-321