Honda ACCORD HYBRID 2005 Service Manual page 971

DTC P0796: A/T Clutch Pressure Control
Solenoid Valve C Stuck OFF
NOTE: Record all freeze data and review General
Troubleshooting Information (see page 14-4) before
y o u troubleshoot.
1. W a r m up the engine to n o r m a l operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid leaks.
3. Drain the ATF (see step 3 on page 14-231) t h r o u g h a
strainer. Inspect the strainer for metal debris or
excessive clutch material.
Does the strainer have metal debris or excessive
clutch material?
YES—Replace the t r a n s m i s s i o n s
NO—Replace the ATF (see step 5 on page 14-231),
then go to step 4.
4. Clear the DTC w i t h the HDS.
5. Test-drive the vehicle in the D, D3, or R position,
and slow d o w n to a stop.
6. Retest-drive the vehicle in the D, D3, or R position,
and slow d o w n to a stop.
7. M o n i t o r the OBD status for P0796 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate a fail?
8. Clear the DTC w i t h the HDS.
9. Choose Clutch Pressure Control (Linear) Solenoid C
in Miscellaneous Test M e n u , and test the A/T clutch
pressure control solenoid valve C w i t h the HDS.
Is the system OK?
YES—Intermittent failure, the system is OK at this
t i m e s
NO—Follow the instructions indicated on the HDS
by the tester result. Go to step 10 if any part is
replaced.
10. Clear the DTC w i t h the HDS.
11. Test-drive the vehicle in the D, D3, or R position,
and s l o w d o w n to a stop.
12. Retest-drive the vehicle in the D, D3, or R position,
and s l o w d o w n to a stop.
13. M o n i t o r the OBD status for P0796 in the DTCs/
Freeze Data in A/T M o d e M e n u for a pass/fail.
Does the result indicate a pass?
YES—The problem has been c o r r e c t e d S
NO—Return to step 8 and recheck.
Y E S — G o t o step 8.
NO—Intermittent failure, the system is OK at this
t i m e . If the tester indicates NOT COMPLETE, return
to step 5 and r e c h e c k s
14-135