Honda ACCORD HYBRID 2005 Service Manual page 924

Automatic Transmission
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
24. Measure the voltage between transmission range
switch connector terminals No. 5 and No. 7.
T R A N S M I S S I O N R A N G E
SWITCH C O N N E C T O R
G N D (BLK)
1 2
3
4
5
y
6 7 8 9 10
ATP
D3
(RED)
Wire side of f e m a l e t e r m i n a l s
Is there voltage?
Y E S — G o t o step 25.
NO—Repair an open in the w i r e between the
transmission range switch and PCM connector
terminal C18, then go to step 26.
25. Measure the voltage between transmission range
switch connector terminals No. 1 and No. 5.
26. Clear the DTC w i t h the HDS.
27. Raise the front of the vehicle, or lift the vehicle up,
make sure it is securely supported, and allow the
front wheels to rotate freely.
28. Start the engine, drive the vehicle in the D position
until the vehicle speed reaches 25 m p h (40 km/h),
then s l o w d o w n and stop the wheels.
29. Turn the ignition switch OFF, restart the engine and
retest-drive the vehicle in the D position until the
vehicle speed reaches 25 m p h (40 km/h), then slow
d o w n and stop the wheels.
30. M o n i t o r the OBD status for P0706 in the DTCs/
Freeze Data in A/T M o d e M e n u for a pass/fail.
Does the result indicate a pass?
YES—The p r o b l e m has been corrected. •
NO—Return to step 6 and recheck.
T R A N S M I S S I O N R A N G E
SWITCH C O N N E C T O R
ATP 2-1 (BLU)
1
G N D (BLK)
1 0
Wire side of f e m a l e t e r m i n a l s
Is there voltage?
YES—Update the PCM if it does not have the latest
software, or substitute a k n o w n - g o o d PCM
(see page 14-7), then recheck. If the s y m p t o m /
indication goes away w i t h a k n o w n - g o o d PCM,
replace the original PCM.H
NO—Repair an open in the w i r e between the
transmission range switch and PCM connector
t e r m i n a l C14, then go to step 26.
14-88