Honda ACCORD HYBRID 2005 Service Manual page 1123

Transmission Housing
R e v e r s e Idler G e a r R e m o v a l /
I n s t a l l a t i o n
R e v e r s e Idler G e a r D i s a s s e m b l y /
I n s p e c t i o n / R e a s s e m b l y
1. Remove the reverse idler gear assembly (A) f r o m
the transmission housing.
8 x 1 . 2 5 m m
26 N m
(2.7 kgf m, 20 Ibfft)
2. Install the reverse idler gear assembly w i t h the t w o
dowel pins (B) in the transmission housing.
1. Remove the snap ring (A), then remove the thrust
washer (B), reverse idler gear (C), needle bearings
(D), and thrust washer (E) f r o m the reverse idler
gear shaft/holder (F).
2. Inspect the reverse idler gear and gear shaft for
excessive wear and damage.
3. Inspect the needle bearings for galling and rough
m o v e m e n t .
4. Install the thrust washer and needle bearings over
the gear shaft.
5. Install the reverse idler gear in the direction s h o w n .
6. Install the thrust washer, then install the snap ring
to secure the idler gear.
14-287