Honda ACCORD HYBRID 2005 Service Manual page 1116

A / T Interlock System
S h i f t L o c k S o l e n o i d T e s t
1. Connect the HDS to the DLC (A).
2. Choose Shift Lock Solenoid Test in Miscellaneous
Test M e n u , and check that the shift lock solenoid
operates w i t h the HDS.
3. Check that the shift lever can be m o v e d out of the P
position w h e n Shift Lock S o l e n o i d : O N . Move the
shift lever back in the P position, and make sure it
locks w i t h Shift Lock Solenoid: OFF.
4. Check that the shift lock releases w h e n the shift
lock release is pushed, and check that it locks w h e n
the shift lock release is released.
5. If the shift lock solenoid does not w o r k properly,
perform shift lock system t r o u b l e s h o o t i n g
(see page 14-276).
S h i f t L o c k S o l e n o i d R e p l a c e m e n t
1. Remove the center console (see page 20-62).
2. Disconnect the shift lock solenoid connector (A),
and remove it f r o m the shift lever bracket base (B).
G
3. Remove the A/T gear position indicator panel light
bulb socket (C).
4. Release the lock tab (D) securing the shift lock
solenoid, and remove the shift lock solenoid.
5. Install the shift lock solenoid plunger (E) and
plunger spring (F) in the new shift lock solenoid (G).
6. A p p l y silicon grease to j o i n t of the shift lock
solenoid plunger, if necessary.
7. Install the new shift lock solenoid by aligning the
joint of the shift lock solenoid plunger w i t h the tip
of the shift lock stop (H).
8. Install the A/T gear position indicator panel light
bulb socket.
9. Install the shift lock solenoid connector on the shift
lever bracket base, then connect the connector.
10. Install the center console (see page 20-62).
14-280