Honda ACCORD HYBRID 2005 Service Manual page 1184

Automatic Transmission
T r a n s m i s s i o n R e a s s e m b l y ( c o n t ' d )
Special Tool Required
Mainshaft holder 07GAB-PF50101 or 07GAB-PF50100
1. Make sure that the ATF magnet is cleaned and
installed in the torque converter housing. Clean
and install the ATF magnet, if necessary.
2. Install the main separator plate and the t w o dowel
pins on the torque converter housing. Then install
the ATF p u m p drive gear (A), driven gear (B), and
ATF p u m p driven gear shaft (C). Install the ATF
p u m p driven gear w i t h its g r o o v e d and chamfered
side facing d o w n .
B
3. Install the torque converter check valve spring and
valve in the torque converter housing.
4. Install the main valve body (seven 6 m m bolt and
three 8 m m bolts). Make sure the ATF p u m p drive
gear (A) rotates s m o o t h l y in the normal operating
direction, and the ATF p u m p driven gear shaft (C)
moves s m o o t h l y in the axial and normal operating
direction.
5. If the ATF p u m p drive gear and ATF p u m p driven
gear shaft do not m o v e s m o o t h l y , loosen the main
valve body bolts. Realign the ATF p u m p driven
gear shaft, and retighten the bolts to the specified
torques, then recheck. Failure to align the ATF
p u m p driven gear shaft correctly w i l l result in a
seized ATF p u m p drive gear or ATF p u m p driven
gear shaft.
6. Install the lubrication check valve, cooler check
valve and cooler check valve spring in the main
valve body. Install the lubrication check valve in the
direction s h o w n in the exploded view.
7. Install the secondary separator plate and the t w o
dowel pins on the main valve body, and install the
secondary valve body (one bolt).
8. Install the three check balls and choke in the
secondary valve body.
9. Install the accumulator separator plate and the t w o
d o w e l pins on the secondary valve body.
10. Position the detent arm on the accumulator
separator plate, and install the detent arm shaft into
the detent a r m t h r o u g h the separator plates to the
main valve body.
11. Install the 8 x 62 m m ATF feed pipes in the main
valve body, and install the accumulator body (11
bolts).
12. Install the regulator separator plate and the t w o
dowel pins on the main valve body.
13. Install the stator shaft w i t h the new O-ring, and
install the regulator valve body (eight bolts).
14. Install the stator shaft stop in the main valve body.
15. Install the ATF strainer w i t h the new O-ring.
16. Install the ATF passage pipe (one bolt) in the torque
converter housing.
14-348