Honda ACCORD HYBRID 2005 Service Manual page 1056

Automatic Transmission
A / T C l u t c h P r e s s u r e C o n t r o l S o l e n o i d V a l v e C T e s t ( c o n t ' d )
14. Install the 8 x 53 m m ATF joint pipe (A) w i t h the
filter side into its m o u n t i n g hole (B).
15. Check the height (A) of the 8 x 53 m m ATF joint
pipe (B) between the t o p (C) of the pipe and the
solenoid valve body m o u n t i n g surface (D). The
height is about 7 m m (0.3 in.) If the height is over
7 m m (0.3 in.), push the pipe until it bottoms in the
accumulator body.
16. Install the new gasket (A) on the transmission
housing, and install the 8 x 34.5 m m ATF joint pipe
(B) w i t h the filter side into the transmission housing
and 8 x 25.2 m m ATF pipe (D).
6 x 1.0 mm
12 N-m
(1.2 k g f m , 8.7 Ibf-ft)
17. Install new O-rings (E) over the ATF joint pipes.
18. Install the A/T clutch pressure control solenoid
valve C.
19. Install the intake air duct and air cleaner housing.
14-220