Honda ACCORD HYBRID 2005 Service Manual page 1038

Automatic Transmission
P r e s s u r e T e s t
Special Tools Required
• A/T clutch pressure gauge set
07406-0020400 or 07406-0020401
• A/T pressure hose, 2,210 m m 07MAJ-PY4011A
• A/T pressure hose adapter 07MAJ-PY40120
1. Before testing, be sure the transmission fluid is
filled to the proper level.
2. Lift the vehicle up on a lift or apply the parking
brake, block rear wheels, and raise the front of the
vehicle. Make sure it is securely supported.
3. A l l o w the front wheels to rotate freely.
4. Remove the splash shield.
5. W a r m up the engine (the radiator fan comes on).
Turn off the engine, and connect the HDS to the
DLC (A).
6. Connect the oil pressure gauge to the line pressure
inspection hole (A). Do not allow dust or other
foreign particles to enter the hole w h i l e connecting
the gauge.
A / T OIL P R E S S U R E
G A U G E S E T W / P A N E L
07406-0020400 or
07406-0020401
A / T P R E S S U R E
H O S E , 2,210 m m
07MAJ-PY4011A
(4 required)
A / T P R E S S U R E
H O S E ADAPTER
07MAJ-PY40120
(4 required)
7. Start the engine, and run it at 2,000 r p m in the P or
N position.
8. Measure the line pressure at the line pressure
inspection hole (A).
NOTE: Higher pressure m a y be indicated if
measurements are made in any shift lever position
other than P o r N.
Pressure
Fluid Pressure
Pressure
Standard Service Limit
Line (A) 9 0 0 - 9 6 0 kPa
( 9 . 2 -
9.8 kgf/cm 2 ,
1 3 0 - 1 4 0 psi)
850 kPa
(8.7 kgf/cm
2
,
120 psi)
14-202