Honda ACCORD HYBRID 2005 Service Manual page 1494

Dashboard
I n s t r u m e n t P a n e l R e m o v a l /
I n s t a l l a t i o n
Special Tools Required
KTC t r i m tool set SOJATP2014 *
• Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Take care not to scratch the dashboard and related
parts.
• Use the appropriate tool f r o m the KTC t r i m tool set to
avoid damage w h e n prying c o m p o n e n t s .
1 . Tilt the steering c o l u m n d o w n .
2. Remove the instrument panel (A).
- 1 Remove the screws (B).
- 2 Gently pull out along the b o t t o m to release the
clips (C) and hooks (D).
- 3 Gently pull out the upper portion of the panel.
- 4 Disconnect the in-car temperature sensor
connector <E) and the air hose (F).
Fastener Locations
B • : S c r e w , 2 C > : Clip, 2
3. Install the panel in the reverse order of removal.
Make sure the in-car temperature sensor connector
is plugged in properly, and the air hose is
connected securely.
I n s t r u m e n t U p p e r V i s o r R e m o v a l /
I n s t a l l a t i o n
NOTE: Take care not to scratch the dashboard and
related parts.
1. Remove these items:
• Instrument panel (see page 20-66)
• Gauge control m o d u l e (see page 22-235)
2. Remove the screws, then remove the instrument
upper visor (A).
Fastener Locations
• : S c r e w , 7
3. Install the visor in the reverse order of r e m o v a l .
20-66