Honda ACCORD HYBRID 2005 Service Manual page 1192

Automatic Transmission
T r a n s m i s s i o n R e a s s e m b l y ( c o n t ' d )
66. Push the locknut against the transmission housing
to seat the range switch into the selector control
shaft, and tighten the locknut to 12 N-m (1.2 kgf-m,
8.7 Ibf-ft) while holding the selector control shaft
w i t h a 6 m m w r e n c h , then bend the lock tabs
against the locknut.
67. Tighten the range switch m o u n t i n g bolts to 12 N-m
(1.2 kgf-m, 8.7 Ibf-ft).
68. Install the control lever (A), spring washer (B), lock
washer (C), and locknut (D) on the selector control
shaft (E).
69. Install the new O-ring (A) on the input shaft
(mainshaft) speed sensor (B), and install the input
shaft (mainshaft) speed sensor.
70. Install the new O-ring (C) on the output shaft
(countershaft) speed sensor (D), and install the
output shaft (coutershaft) speed sensor and the
sensor washer (E).
7 1 . Install the 4th clutch transmission fluid pressure
switch (A) w i t h the new sealing washer (B). Tighten
the switch w i t h the metal part.
14-356