Honda ACCORD HYBRID 2005 Service Manual page 535

18. Check for continuity between engine mount control
unit 20P connector terminals No. 5 and No. 17.
ENGINE MOUNT CONTROL UNIT 20P CONNECTOR
CANH (WHT)
1 2 3 4
i—i
5 6
A
8 9
10 11 12
/
14 15 16 17
A
/
20
CANL (RED)
Wire side of female terminals
Is there continuity?
YES—Replace the engine m o u n t control unit
(see page 11-323), then go to step 19.
NO—Repair open in the wire between the PCM
(E15 (E26)*) and the engine m o u n t control unit
(No. 5 (No. 17)*), then g o t o step 19.
* : CANL line
19. Reconnect all connectors.
20. Turn the ignition switch ON (II).
21. Reset the PCM with the HDS.
22. Do the PCM idle learn procedure (see page 11-340).
23. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
YES—if DTC P15AB is indicated, check for poor
connections or loose terminals at the engine mount
control unit and the PCM, then go to step 1. If any
other Temporary DTCs or DTCs are indicated, go to
the indicated DTCs troubleshooting.
NO—Troubleshooting is c o m p l e t e . •