Honda ACCORD HYBRID 2005 Service Manual page 747

29. Measure resistance between body g r o u n d and the
MPI module terminals (A), (B) and (C) individually.
NOTE: Use 250 V range of the insulation resistance
tester.
Is there 350 kQ or higher?
Y E S — G o t o step 29.
NO—Replace the MPI module (see page 12-144),
then go to step 49.
30. Disconnect the motor power cable (A).
NOTE: Refer to disconnecting m o t o r power cable
connector f r o m motor startor (see page 12-3).
3 1 . Measure for resistance between body ground and
the m o t o r power cable terminals (A), (B) and (C)
individually.
NOTE: If the m o t o r power cable terminals are wet,
dry t h e m w i t h a clean t o w e l . Do not use
compressed air to dry the motor power cables.
Is there 350 kQ or higher?
Y E S — G o t o step 32.
NO—Replace the m o t o r power cable (see page
12-148), then go to step 49.
32. Measure for resistance between body g r o u n d and
the m o t o r stator terminals (A), (B) and (C)
individually.
NOTE: If the motor power cable terminals are wet,
w a i t until it dry.
Is there 350 kQ or higher?
YES—Go to step 57.
NO—Replace the motor stator (see page 12-153),
then go to step 49.
(cont'd)
12-69