Honda ACCORD HYBRID 2005 Service Manual page 1046

Automatic Transmission
A / T C l u t c h P r e s s u r e C o n t r o l S o l e n o i d V a l v e A T e s t
1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid A
in Miscellaneous Test M e n u on the HDS.
3. Test the A/T clutch pressure control solenoid valve
A w i t h the HDS.
• If the valve tests OK, the test is complete.
Disconnect the HDS.
• If the valve does not test OK, f o l l o w the
instructions on the HDS.
• If the valve does not test OK, and the HDS does
not determine the cause, go t o step 4.
4. Get the customer's radio anti-theft code (navigation
code), and write d o w n the customer's audio
presets.
5. Disconnect the negative t e r m i n a l f r o m the battery,
then disconnect the positive t e r m i n a l .
6. Remove the battery h o l d - d o w n bracket, and
remove the battery and battery tray.
7. Remove the intake air duct and air cleaner housing.
8. Remove the battery base.
9. Disconnect the A/T clutch pressure control solenoid
valve A connector.
10. Measure the A/T clutch pressure control solenoid
valve A resistance at the connector terminals.
Standard: 3—10 Q
• If the resistance is out of standard, replace the
A/T clutch pressure control solenoid valve A
(see page 14-216).
• If the resistance is w i t h i n the standard, go to step
11.
11. Connect the negative battery terminal to the
solenoid valve A connector t e r m i n a l No. 2, and
connect the positive battery terminal to the
connector terminal No. 1.
• If a clicking sound is heard, the valve is OK.
Reconnect the connector, and install all removed
parts.
• If no clicking sound is heard, go to step 12.
14-210