Honda ACCORD HYBRID 2005 Service Manual page 1343

Installation
1. Lower the rear suspension, and position the
damper (A) in the body.
A
2. Loosely install the flange nuts (B) onto the top of
the damper.
3. Loosely install the flange bolt (A) on the bottom of
the damper. Connect the stabilizer link j B ) on the
bracket (C), and loosely install the flange nut (D).
E
4. Raise the rear suspension w i t h a floor jack load the
vehicle's w e i g h t , and tighten the flange bolt to the
specified torque value.
5. Tighten the flange nut w h i l e holding the joint pin
(E) w i t h a hex w r e n c h (F).
6. Tighten the t w o flange nuts on t o p of the damper to
the specified torque value.
7. Install the rear seat side bolster (see page 20-95).
8. Clean the mating surface of the brake disc and the
inside of the w h e e l , then install the rear w h e e l .
9. Check the rear wheel alignment, and adjust it if
necessary (see page 18-7).
18-43